Maybe someone can see what I'm doing stupidly here as I'm going blind.
I have some folders that have ?9999 messages that I don't want to break
up, so I want to go to a 5 digit message number in scan
If I type the following, taken from /etc/nmh/scan.defaults with the 4
changed to 5 it works fine.
scan -format '%5(msg)%<(cur)+%| %>%<{replied}-%?{encrypted}E%| %>
%02(mon{date})/%02(mday{date})%<{date} %|*%>
%<(mymbox{from})%<{to}To:%14(decode(friendly{to}))%>%>
%<(zero)%17(decode(friendly{from}))%> %(decode{subject})%<{body}<<%{body}>>%>'
If I put the following
scan: -format '%5(msg)%<(cur)+%| %>%<{replied}-%?{encrypted}E%| %>
%02(mon{date})/%02(mday{date})%<{date} %|*%>
%<(mymbox{from})%<{to}To:%14(decode(friendly{to}))%>%>
%<(zero)%17(decode(friendly{from}))%> %(decode{subject})%<{body}<<%{body}>>%>'
into my .mh_profile, it says
scan: bad message list %>%<{replied}-%?{encrypted}E%|
Is there something special that I need to do in .mh_profile?
Does something need extra escaping?
Thanks,
Jon
_______________________________________________
Nmh-workers mailing list
Nmh-workers(_at_)nongnu(_dot_)org
https://lists.nongnu.org/mailman/listinfo/nmh-workers