Tim,
Remote bridging over Frame Relay networks is specified in RFC 2427, and
over PPP by RFC 1638. RFC 1638 also contains a good introduction to remote
bridging in general. You should probably also check out IEEE 802.1D (aka
ISO/IEC 15802-3) and 802.1G (aka ISO/IEC 15802-5). The latter two need to
be downloaded from the IEEE (see http://standards.ieee.org/).
Cheers,
Andy
-------
At 11:45 AM 4/17/00 -0500, Timothy Behne wrote:
Can anyone help point me in the direction of an RFC, draft, or other
information that might be helpful in sending Ethernet data across a
slower-speed media (such as in a remote bridge implementation)? For
instance, sending 100 BaseT Ethernet data across a DS3 link.
Thanks in advance,
Tim Behne
Tadiran Microwave Networks
-
This message was passed through ietf+censored(_at_)alvestrand(_dot_)no, which
is a sublist of ietf(_at_)ietf(_dot_)org(_dot_) Not all messages are passed.
Decisions on what to pass are made solely by Harald Alvestrand.
________________________________________________________________________
Andrew G. Malis amalis(_at_)lucent(_dot_)com phone:978 952-7414 fax:978
392-2074
Lucent Technologies 1 Robbins Road Westford, MA 01886