Folks,
We would like to announce a BoF at the upcoming IETF, leading to identify what
limitations and considerations apply to IPv6 adoption over IEEE 802.16(e), and
to propose available solutions. A mailing list is set up at
16ng(_at_)eeca16(_dot_)sogang(_dot_)ac(_dot_)kr and a proposed description is
below.
==========================================
IPv6 over IEEE 802.16(e) Networks BoF (16ng)
CHAIRS:
Soohong Daniel Park<soohong(_dot_)park(_at_)samsung(_dot_)com>
Gabriel Montenegro<gabriel_montenegro_2000(_at_)yahoo(_dot_)com>
DESCRIPTION:
Broadband Wireless Access Network addresses the inadequacies of low bandwidth
wireless communication for user requirements such as high quality data/voice
service, fast mobility, wide coverage, etc. The IEEE 802.16 Working Group on
Broadband Wireless Access Standards develops standards and recommended
practices to support the development and deployment of broadband Wireless
Metropolitan Area Networks. In addition, IEEE 802.16e supports mobility over
IEEE 802.16 as an amendment to the IEEE 802.16 specification.
Recently, much work is in progress by the WiMAX Forum. In particular, its NWG
(Network Working Group) is responsible for the IEEE 802.16(e) network
architecture (e.g., IPv4, IPv6, Mobility, Interworking with different networks,
AAA, etc). The NWG is thus taking on work at layers above those defined by the
IEEE 802 standards (typically limited to the physical and link layers only).
Similarly, WiBro (Wireless Broadband) is a Korean effort based on the IEEE
802.16e specification which focuses on the 2.3 GHz spectrum band.
IEEE 802.16(e) is different from existing wireless access technologies such as
IEEE 802.11 or 3G. Accordingly, the use of IP over an IEEE 802.16(e) link is
currently undefined, and will benefit from IETF input and specification. For
example, even though Neighbor Discovery has been specified to work over
point-to-point type links (e.g., as available in 3G), it applies most naturally
to link technologies capable of native multicasing. Thus, it is not yet clear
how it would work over IEEE 802.16(e) networks. Even though these supports a
PMP (Point-to-Multipoint) mode, there is no provision for multicasting IP
packets, hindering the basic standard IPv6 operation. An IEEE 802.16(e)
connection for IP packet transfer is a point-to-point unidirectional mapping
between medium access control layers at the ubscriber station and the base
station. This eventually requires convergence protocols to emulate the desired
service on network entities such as base stations, which may limit IPv6
features. As for fast mobility, the characteristics of IEEE 802.16e link-layer
operation may require an amendment to the Fast Handover Mobile IPv6 scheme (RFC
4068), something which may be pursued in the MIPSHOP WG.
The principal objective of the 16ng BoF is to identify what limitations and
considerations apply to IPv6 adoption over IEEE 802.16(e), and to propose
available solutions. The working group may issue recommendations to IEEE
802.16(e) suggesting protocol modifications for better IP support.
In 2006, WiBro deployment will begin, and the WiMAX Forum is slated to specify
IPv6 operation over IEEE 802.16(e) in 2006. Accordingly, the working group will
work and coordinate with the WiMAX Forum and with the WiBro efforts.
MAILING LIST:
General Discussion: 16ng(_at_)eeca16(_dot_)sogang(_dot_)ac(_dot_)kr
To Subscribe: http://eeca16.sogang.ac.kr/mailman/listinfo/16ng
Archive: http://eeca16.sogang.ac.kr/pipermail/16ng
REFERENCES:
http://www.ietf.org/internet-drafts/draft-jang-mipshop-fh80216e-00.txt
http://www.watersprings.org/pub/id/draft-jin-ipv6-over-ieee802.16-00.txt
http://www.ietf.org/internet-drafts/draft-jee-mip4-fh80216e-00.txt
IPv6 over IEEE 802.16(e) Networks Problem Statements (coming soon)
Regards,
Gabriel & Daniel
16ng BoF co-chairs
_______________________________________________
Ietf mailing list
Ietf(_at_)ietf(_dot_)org
https://www1.ietf.org/mailman/listinfo/ietf