In message <m2r4t0jx2l(_dot_)wl%randy(_at_)psg(_dot_)com>, Randy Bush writes:
- 'Basic Requirements for IPv6 Customer Edge Routers'
<draft-ietf-v6ops-6204bis-09.txt> as Informational RFC
this document persists in confusing routing and forwarding.
there are no routing protocols, a la 1812, here. there is confused text
such as
4.1. General Requirements
The IPv6 CE router is responsible for implementing IPv6 routing; that
is, the IPv6 CE router must look up the IPv6 destination address in
its routing table to decide to which interface it should send the
packet.
which i thought was forwarding, not routing.
It's static routing. And if there is down stream PD there will be
next hop routers as well as interfaces in the table.
RA/RD doeth not a router make.
randy
_______________________________________________
v6ops mailing list
v6ops(_at_)ietf(_dot_)org
https://www.ietf.org/mailman/listinfo/v6ops
--
Mark Andrews, ISC
1 Seymour St., Dundas Valley, NSW 2117, Australia
PHONE: +61 2 9871 4742 INTERNET: marka(_at_)isc(_dot_)org