*Comments on I-D Action: draft-ietf-oauth-jwsreq-11.txt*
Two editorial comments first :
1. Guidance is a mass noun, not a count noun, plural doesn't make sense.
Please change "guidances" into "guidance" twice in Section 11.
2. In Section 12 : Please remove my name (Denis Pinkas) from this section.
Other comments:
3. Section 1.1 (from boiler plate) states: The key words "MUST", "MUST
NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD",
"SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are
to be interpreted as described in RFC 2119 [RFC2119].
There is not a single other occurrence of the word SHALL within this
document. In such case, I wonder how this document can be normative.
There are however many (useful) "non-normative examples. A non-normative
example does not replace requirements.
Section 4 states:
*A Request Object (Section 2.1) is used to provide authorization*
*request parameters for an OAuth 2.0 authorization request.It*
*contains OAuth 2.0 [RFC6749] authorization request parameters*
*including extension parameters**.*
**
RFC 6749 contains 75 pages, but does not contain a single occurrence of
the wording "authorization request parameter" nor of "extension parameter".
There should be either references to one or more specific sections of
this document or, even better, a list of the mandatory/recommended/possible
authorization request parameters as well as a list of
mandatory/recommended/possible extension parameters should be included
in this document.
A clear distinction should be made between the parameters used to
authenticate the request and the other ones.
4. The introduction states on page 4:
(a) (integrity protection) The request can be signed so that the
integrity of the request can be checked;
This should be changed into:
(a) (integrity protection) The request can be authenticated either
using a digital signature or using encryption under a secret key
so that the integrity of the request can be checked;
5. The introduction states on page 4:
(d) (collection minimization) The request can be *signed* by a third
party attesting that the authorization request is compliant tocertain
policy.
The request is not /signed/ by a third party.
However, later on, there is the following explanation:
In addition, it allows requests to be prepared by a third party so that
a client application cannot request
more permissions than previously agreed.
If it is the intent, the sentence should be rephrased as:
(d) (collection minimization) The request can be *verified* by a third
party attesting that the authorization request is compliant tocertain
policy.
6. Section 10.1. the text states:
*When sending the authorization request object through "request"*
*parameter, it MUST either be signed using JWS [RFC7515] or encrypted*
*using JWE [RFC7516] with then considered appropriate algorithm.*
The wording"with then considered appropriate algorithm"is too vague.
This should be changed into:
*When sending the authorization request object through "request"*
*parameter, it MUST either be signed using JWS [RFC7515] or encrypted*
*using JWE [RFC7516] using a symmetric key algorithm.*
7. Section 10.2 states:
This means that the request object is going to be prepared fresh each
time an authorization request is madeand caching cannot be used.
What are the implications ? Is it required/recommended to use a nonce ?
The text should be made clearer.
8. Section 10.3 states:
10.3.Request Source Authentication
The source of the Authorization Request MUST always be verified.
There are several ways to do it in this specification.
(a)Verifying the JWS Signature of the Request Object.
It seems that the case of using a JWE encrypted using a secret key
algorithm has been forgotten here. Please add it.
9. Section 10.3 states at its very end:
An extension specification
should be created as a preventive measure to address potential
vulnerabilities that have not yet been identified.
Writing a document for vulnerabilities that have not yet been identified
is speculative. It would rather be better
either to remove this sentence or to explain what is meant by it.
10. Section 11.1 states:
*11.1.Collection limitation*
**
*When the Client is being granted access to a protected resource*
*containing personal data, the Client SHOULD limit the collection of*
*personal data to that which is within the bounds of applicable law*
*and strictly necessary for the specified purpose(s).***
The /presentation/ of personal data should be limited whether or not the
protected resource contains personal data.
It is proposed to change this text into:
*When the Client requests an access to a protected resource, the Client*
*SHOULD limit the presentation of personal data to that which is within *
*the bounds of applicable law and strictly necessary for the specified *
*purpose(s).***
11. Section 11.2.1 states:
11.2.1.Request Disclosure
This specification allows extension parameters.
It would be useful to name either all of them or some of them. RFC 6749
is not crystal clear about this.
Denis Pinkas (DP Security Consulting SAS)
==============================================================
The IESG has received a request from the Web Authorization Protocol WG
(oauth) to consider the following document:
- 'The OAuth 2.0 Authorization Framework: JWT Secured Authorization
Request (JAR)'
<draft-ietf-oauth-jwsreq-11.txt> as Proposed Standard
The IESG plans to make a decision in the next few weeks, and solicits
final comments on this action. Please send substantive comments to the
ietf(_at_)ietf(_dot_)org mailing lists by 2017-02-13. Exceptionally, comments
may be
sent to iesg(_at_)ietf(_dot_)org instead. In either case, please retain the
beginning of the Subject line to allow automated sorting.
Abstract
The authorization request in OAuth 2.0 described in RFC 6749 utilizes
query parameter serialization, which means that Authorization Request
parameters are encoded in the URI of the request and sent through
user agents such as web browsers. While it is easy to implement, it
means that (a) the communication through the user agents are not
integrity protected and thus the parameters can be tainted, and (b)
the source of the communication is not authenticated. Because of
these weaknesses, several attacks to the protocol have now been put
forward.
This document introduces the ability to send request parameters in a
JSON Web Token (JWT) instead, which allows the request to be JWS
signed and/or JWE encrypted so that the integrity, source
authentication and confidentiality property of the Authorization
Request is attained. The request can be sent by value or by
reference.
The file can be obtained via
https://datatracker.ietf.org/doc/draft-ietf-oauth-jwsreq/
IESG discussion can be tracked via
https://datatracker.ietf.org/doc/draft-ietf-oauth-jwsreq/ballot/
No IPR declarations have been submitted directly on this I-D.
The document contains these normative downward references.
See RFC 3967 for additional information:
rfc6234: US Secure Hash Algorithms (SHA and SHA-based HMAC and HKDF)
(Informational - IETF stream)
rfc6819: OAuth 2.0 Threat Model and Security Considerations (Informational
- IETF stream)
rfc6973: Privacy Considerations for Internet Protocols (Informational -
IAB stream)
Note that some of these references may already be listed in the acceptable
Downref Registry.
_______________________________________________
OAuth mailing list
OAuth(_at_)ietf(_dot_)org
https://www.ietf.org/mailman/listinfo/oauth