-----Original Message-----
From: Ian Ringrose
I have just started to look at using XSL/FO for a new
project. One of our requirements is to be able to fit text
into a cell of a table. If the cell is not big enough to
hold the text at the requested size, then I wish the size
of the text to be reduced so that it will all fit into the
cell. Is this possible with XSL/FO, if so where to I start?
Words of one syllable no.
XSL-FO, as delivered, has no feedback from the laid out page
back to the stylesheet.
HTH DaveP.
--
DISCLAIMER:
NOTICE: The information contained in this email and any attachments is
confidential and may be privileged. If you are not the intended
recipient you should not use, disclose, distribute or copy any of the
content of it or of any attachment; you are requested to notify the
sender immediately of your receipt of the email and then to delete it
and any attachments from your system.
RNIB endeavours to ensure that emails and any attachments generated by
its staff are free from viruses or other contaminants. However, it
cannot accept any responsibility for any such which are transmitted.
We therefore recommend you scan all attachments.
Please note that the statements and views expressed in this email and
any attachments are those of the author and do not necessarily represent
those of RNIB.
RNIB Registered Charity Number: 226227
Website: http://www.rnib.org.uk