Hi all,
Need help with the following problem which I suppose should use xsl:group in
XSLT2.0. What I want to do is to group the result by <type> element (type1 and
type2). Element <range> has all the valid values and this should be used to
find out all values that fall between <start> and <end> element for each
<record>. So expected result is
type1: 0,2,4,5,6,7
type2: 0,7,8,9,A,B,C,D,E,F
<data>
<range>0,1,2,3,4,5,6,7,8,9,A,B,C,D,E,F</range>
<record>
<start>0</start>
<end>0</end>
<node>
<type>type1</type>
</node>
</record>
<record>
<start>0</start>
<end>0</end>
<node>
<type>type2</type>
</node>
</record>
<record>
<start>2</start>
<end>2</end>
<node>
<type>type1</type>
</node>
</record>
<record>
<start>4</start>
<end>7</end>
<node>
<type>type1</type>
</node>
</record>
<record>
<start>7</start>
<end>F</end>
<node>
<type>type2</type>
</node>
</record>
</data>
Thanks.
Disclaimer :
The contents of this e-mail including any attachments are intended only
for the person or entity to which this e-mail is addressed. If you are not,
or believe you may not be, the intended recipient, please advise the sender
immediately by return e-mail, delete this e-mail and destroy any copies.
Tenix does not warrant nor guarantee that this email communication is free
from errors, virus, interception or interference.
--~------------------------------------------------------------------
XSL-List info and archive: http://www.mulberrytech.com/xsl/xsl-list
To unsubscribe, go to: http://lists.mulberrytech.com/xsl-list/
or e-mail: <mailto:xsl-list-unsubscribe(_at_)lists(_dot_)mulberrytech(_dot_)com>
--~--