Correction: Remove the seg element from Gerrit XSLT
<seg>-------
<xsl:sequence select="current-group()" />
</seg>-------
Regards,
Ramkumar
===========================================================
***Disclaimer***
This email, and any attachments ("this email"), is confidential. If you are not
the addressee
please tell the sender immediately, and destroy this email without using,
sending or storing
it. Any opinions, express or implied, in this email, are those of the sender,
and are not
necessarily approved by Hurix Systems. Except as expressly stated, this e-mail
should not be
regarded as an offer, solicitation, recommendation or agreement to buy or sell
products or
services, or to enter into any contract. E-mail transmissions are not secure
and may suffer
errors, viruses, delay, interception and amendment. Hurix Systems does not
accept liability
for damage caused by any of the foregoing.
HURIX SYSTEMS MAY MONITOR ALL INCOMING AND OUTGOING MAILS
============================================================
--~------------------------------------------------------------------
XSL-List info and archive: http://www.mulberrytech.com/xsl/xsl-list
To unsubscribe, go to: http://lists.mulberrytech.com/xsl-list/
or e-mail: <mailto:xsl-list-unsubscribe(_at_)lists(_dot_)mulberrytech(_dot_)com>
--~--