ietf
[Top] [All Lists]

RE: Last Call: <draft-ietf-pwe3-redundancy-bit-06.txt> (Pseudowire Preferential Forwarding Status Bit) to Proposed Standard

2012-03-07 14:08:50
Ooops. Thank you for pointing this out Stewart. I will make the update and 
publish a new revision.

Mustapha. 

-----Original Message-----
From: Stewart Bryant [mailto:stbryant(_at_)cisco(_dot_)com] 
Sent: Wednesday, March 07, 2012 12:48 PM
To: draft-ietf-pwe3-redundancy-bit(_at_)tools(_dot_)ietf(_dot_)org
Cc: ietf(_at_)ietf(_dot_)org; pwe3(_at_)ietf(_dot_)org
Subject: Re: Last Call: <draft-ietf-pwe3-redundancy-bit-06.txt> (Pseudowire 
Preferential Forwarding Status Bit) to Proposed Standard


Authors

There was on point that I notice that you did not address from the AD review 
and so I am picking it up as a LC comment:

In section 10 you say:

    "This document makes the following update to the PwOperStatusTC
    textual convention in RFC5542 [8]: "

This update should be recorded in the metadata (top left front page) and it is 
usual to put a one line note in the abstract.

Stewart



On 07/03/2012 17:00, The IESG wrote:
The IESG has received a request from the Pseudowire Emulation Edge to 
Edge WG (pwe3) to consider the following document:
- 'Pseudowire Preferential Forwarding Status Bit'
   <draft-ietf-pwe3-redundancy-bit-06.txt>  as a Proposed Standard

The IESG plans to make a decision in the next few weeks, and solicits 
final comments on this action. Please send substantive comments to the 
ietf(_at_)ietf(_dot_)org mailing lists by 2012-03-21. Exceptionally, comments 
may 
be sent to iesg(_at_)ietf(_dot_)org instead. In either case, please retain 
the 
beginning of the Subject line to allow automated sorting.

Abstract


    This document describes a mechanism for standby status signaling of
    redundant pseudowires (PWs) between their termination points. A set
    of redundant PWs is configured between provider edge (PE) nodes in
    single-segment pseudowire (SS-PW) applications, or between
    terminating provider edge (T-PE) nodes in multi-segment pseudowire
    (MS-PW) applications.

    In order for the PE/T-PE nodes to indicate the preferred PW to use
    for forwarding PW packets to one another, a new status bit is needed
    to indicate a preferential forwarding status of Active or Standby for
    each PW in a redundant set.

    In addition, a second status bit is defined to allow peer PE nodes to
    coordinate a switchover operation of the PW.






The file can be obtained via
http://datatracker.ietf.org/doc/draft-ietf-pwe3-redundancy-bit/

IESG discussion can be tracked via
http://datatracker.ietf.org/doc/draft-ietf-pwe3-redundancy-bit/ballot/


No IPR declarations have been submitted directly on this I-D.


_______________________________________________
IETF-Announce mailing list
IETF-Announce(_at_)ietf(_dot_)org
https://www.ietf.org/mailman/listinfo/ietf-announce



--
For corporate legal information go to:

http://www.cisco.com/web/about/doing_business/legal/cri/index.html


_______________________________________________
Ietf mailing list
Ietf(_at_)ietf(_dot_)org
https://www.ietf.org/mailman/listinfo/ietf