Hello All, I have alittle problem, my cisco 2610, which is in a production
environment, is running NAT on ISDN, this router only has one thernet
interface, and its address has been assigned 10.10.1.1 255.255.255.0, and
when I do a show arp on it, it thinks that has 10.10.1.1 and 10.10.1.15?????
why is this. I have tried to clear the arp table, and the nat table, but to
o avail..heres what I get from show arp...
Protocol Address Age (min) Hardware Addr Type Interface
Internet 10.10.1.1 - 00d0.c0fc.81c0 ARPA Ethernet0/0
Internet 10.10.1.15 - 00d0.c0fc.81c0 ARPA Ethernet0/0
Internet 10.10.1.100 3 00b0.d0c1.e9f2 ARPA Ethernet0/0
Internet 10.10.1.103 3 00b0.d0f0.f21f ARPA Ethernet0/0
<snip>
thanks everyone....
---------------
Hagop R. Karaoghlanian, CCNP
Network Specialist
AT&T Canada IES
905 King St West
416-341-5876
hkaraoghlanian(_at_)corp(_dot_)attcanada(_dot_)ca
"Gold leads into gold, then into restlessness, and finally into crushing
misery." Kahlil Gibran