Section 3 - After the BNG responds to the user with
an Advertise message, the user requests for a DHCP 6rd Option by
carrying a Parameter Request option (55) [RFC2132].
Per the Figure 1 in Section 3, the above 'Advertise message' sounds the
DHCPv4 message of 'DHCPOFFER (2)'.
(http://www.iana.org/assignments/bootp-dhcp-parameters/bootp-dhcp-parameters
.xml)
Section 3 - If the DHCP server to which the DHCP Request message was sent at
time
T1 has not responded, the DHCP client enters the REBINDING state and
attempts to contact any server.
Per the Figure 5 in RFC2131, the above 'T1' sounds 'T2'.
(http://www.rfc-editor.org/rfc/rfc2131.txt)
Best Regards,
Leaf
-----Original Message-----
From: softwires-bounces(_at_)ietf(_dot_)org
[mailto:softwires-bounces(_at_)ietf(_dot_)org] On
Behalf Of The IESG
Sent: Friday, November 16, 2012 5:39 AM
To: IETF-Announce
Cc: softwires(_at_)ietf(_dot_)org
Subject: [Softwires] Last Call:
<draft-ietf-softwire-6rd-radius-attrib-07.txt> (RADIUS Attribute for 6rd) to
Proposed Standard
The IESG has received a request from the Softwires WG (softwire) to consider
the following document:
- 'RADIUS Attribute for 6rd'
<draft-ietf-softwire-6rd-radius-attrib-07.txt> as Proposed Standard
The IESG plans to make a decision in the next few weeks, and solicits final
comments on this action. Please send substantive comments to the
ietf(_at_)ietf(_dot_)org mailing lists by 2012-11-29. Exceptionally, comments
may be
sent to iesg(_at_)ietf(_dot_)org instead. In either case, please retain the
beginning
of the Subject line to allow automated sorting.
Abstract
IPv6 Rapid Deployment (6rd) is one of the most popular methods to
provide both IPv4 and IPv6 connectivity services simultaneously
during the IPv4/IPv6 co-existing period. The Dynamic Host
Configuration Protocol (DHCP) 6rd option has been defined to
configure 6rd Customer Edge (CE). However, in many networks, the
configuration information may be stored in Authentication
Authorization and Accounting (AAA) servers while user configuration
is mainly from Broadband Network Gateway (BNG) through DHCP protocol.
This document defines a Remote Authentication Dial In User Service
(RADIUS) attribute that carries 6rd configuration information from
AAA server to BNG.
The file can be obtained via
http://datatracker.ietf.org/doc/draft-ietf-softwire-6rd-radius-attrib/
IESG discussion can be tracked via
http://datatracker.ietf.org/doc/draft-ietf-softwire-6rd-radius-attrib/ballot
/
No IPR declarations have been submitted directly on this I-D.
_______________________________________________
Softwires mailing list
Softwires(_at_)ietf(_dot_)org
https://www.ietf.org/mailman/listinfo/softwires