My mistake (surprise, surprise ;-) ... the message separator definition had
to be: -msgsep ',\d+;\d{12}$'
That converted all 100 messages.
----------------------------------------------------
Stefan Kramer \|/ skramer(_at_)cac(_dot_)washington(_dot_)edu
----------------------------------------------------
On Fri, 15 Nov 1996, Stefan Kramer wrote:
#
# In using MHonArc to convert message folders, found that larger messages end
# up missing from the HTML-output. In a test with a folder of 100 messages,
# the four largest ones, ranging in size from 10,303 to 27,415 bytes, were
# the ones omitted from the conversion; the next smaller one, 9,364, and all
# smaller were converted OK (is there something magic about 10,000 bytes of
# message size?). I saved those four to a separate folder, and when MHonArc
# encountered that one, it just "said": "No new messages". Any leads or
# suggestions (that don't involve programming ;-) would be appreciated ...
#
# ------------------------------------------------------------
# Stefan Kramer skramer(_at_)cac(_dot_)washington(_dot_)edu
# Network Information Center http://www.washington.edu/nic/
# Computing & Communications University of Washington
# ------------------------------------------------------------
#
# P.S.: I'm using Pine 3.95 and MHonArc version 1.1.0 (I know, not the latest
# ;-) on Ultrix, the folder in question is in Tenex format, and I'm
# specifying (because of the Tenex folder format):
#
# -msgsep ',\d{4};\d{12}$'
#
#
#
#