ietf
[Top] [All Lists]

draft-ietf-ipfix-protocol-26.txt

2007-09-25 04:38:08
I reviewed draft-ietf-ipfix-protocol-26.txt as part of the Transport
Area review effort.

I did not find any particular issues in the described technology - a few
nits:

section 3.1 "Export Time" someday the IETF needs to stop using 32-bit
"seconds since 1 jan 1970" for timing - at least within in the next 31
years

section 6.1.2 - it might be reasonable to add the IEEE 8-byte MAC
address as an address type - this is used in ZigBee and may be in wider
use in the future

section 10.3.3 - a max packet size of 1280 could be used if the
connection is known to be running in an IPv6-only environment

I'm not sure why the packet size discussion is only listed for UDP - it
seems like the same restriction should apply to all protocols -
fragmentation is not your friend

Historically the biggest issue with IPFIX has been that most
implementers want to run it over UDP with consequences be dammed.  -
this was weaseled in the IPFIX Requirements document (RFC 3917) by
requiring (in section 6.3.1) that "For the data transfer, a congestion
aware protocol must be supported."  This draft meets that requirement by
making the implementation of SCTP a MUST.  That will not stop many
implementers from ignoring the requirement for implementation or users
to enable UDP and thus creating a potentially very high bandwidth
non-congestion avoiding fire hose that can quite easily wipe out a net
by misconfiguration or become a DoS engine by purposeful configuration.

I'm not sure if anything can be actually be done about this risk - It
might help some to say that UDP is a "MUST NOT" but I doubt it - in any
case it would help somewhat, imho, to expand section 10.3 to be clearer
about the threats posed by any use of a non-congestion avoiding
transport protocol or to do that in the Security Considerations section

Scott

_______________________________________________
Ietf mailing list
Ietf(_at_)ietf(_dot_)org
https://www1.ietf.org/mailman/listinfo/ietf

<Prev in Thread] Current Thread [Next in Thread>