|
Re: Last Call: <draft-ietf-6man-rfc1981bis-04.txt> (Path MTU Discovery for IP version 6) to Internet Standard
2017-03-24 18:06:29
On 17/03/2017, 21:56, Bob Hinden wrote:
Gorry,
Thanks for the detailed review.
Several of the reviews have suggested significant changes to this document.
The working group was trying to make a few changes to bring it into alignment
with some changes to rfc2460bis (based on updating documents). It was not
attempting a major rewrite when advancing it to Internet Standard. The
alternative that the working group discussed was to file errata on RFC1981 and
leave it to a future document update.
I don’t think many of these changes can be done and still advance it to Internet Standard. If
we can’t advance the current document, then the w.g. may want to just do the errata and
withdraw the advancement request. Of course, if people want to work on a revision of IPv6 Path MTU
Discovery, it would be welcomed, but it won’t be able to advanced to Internet Standard.
Comments below.
Thanks,
Bob
Thanks Bob,
I note the question of status, but in this case, there's a lot happened
in the Internet since this PS was first published, and much of this was
in the transport area. Please see replies to comments below. I'm happy
to discuss or refine text, if this helps.
Gorry
On Feb 14, 2017, at 9:23 AM, Gorry
Fairhurst<gorry(_at_)erg(_dot_)abdn(_dot_)ac(_dot_)uk> wrote:
I have some late transport comments on this ID. The update seems to retain a
lot of thinking that is really historical and I'd really encourage people to
look again to making the document uptodate.
Detailed comments follow.
Best wishes,
Gorry
----
The following text strikes me as a little odd in an update:
" Moreover, TCP implementations that follow the "slow-
start" congestion-avoidance algorithm [CONG] typically calculate and
cache several other values derived from the PMTU. It may be simpler
to receive asynchronous notification when the PMTU changes, so that
these variables may be updated.”
- A modern TCP caches at least some path information in the TCB, why start with
this clause at all:
"Moreover, TCP implementations that follow the "slow start" congestion-avoidance
algorithm [CONG] typically calculate and”
and simply replace this with something like:
"TCP implementations”?
——
To clarify, you are suggesting to replace it with:
TCP implementations typically cache several other values derived
from the PMTU. It may be simpler to receive asynchronous notification when
the PMTU changes, so that these variables may be updated.
I think that is editorial, and OK to change. The paragraph will read:
The TCP layer must track the PMTU for the path(s) in use by a
connection; it should not send segments that would result in packets
larger than the PMTU. A simple implementation could ask the IP layer
for this value each time it created a new segment, but this could be
inefficient. TCP implementation typically cache several other values
derived from the PMTU. It may be simpler to receive asynchronous
notification when the PMTU changes, so that these variables may be
updated.
Thanks. Seems better, although I would suggest to revise this in this way:
A packetization layer layer (e.g., TCP) must track the PMTU
for the path(s) in use by a
connection; it should not send segments that would result in packets
larger than the PMTU, except to probe during PMTU discovery.
A simple implementation could ask the IP layer
for this value each time it created a new segment, but this could be
inefficient. An implementation typically caches other values
derived from the PMTU. It may be simpler to receive asynchronous
notification when the PMTU changes, so that these variables may be
also updated.
- This would fix typos, and also make the text relevant to transport protocols,
rather than only TCP. Which is I beleive the correct interpretation.
The following text also seems to not reflect a modern TCP stack:
" It is sufficient
to treat this as any other dropped segment, and wait until the
retransmission timer expires to cause retransmission of the segment.”
(and following 3 paras).
Could this be replaced by text that does not exclude modern retransmission
methods:
" It is sufficient
to treat this in the same way as any other dropped segment, and
will be recovered by normal retransmission methods.”
Yes, resulting in:
When a Packet Too Big message is received, it implies that a packet
was dropped by the node that sent the ICMP message. It is sufficient
to treat this in the same way as any other dropped segment, and will
be recovered by normal retransmission methods. If the Path MTU
Discovery process requires several steps to find the PMTU of the full
path, this could delay the connection by many round-trip times.
Good. Seems much better.
—
There is a block of text that describes retransmission triggered by ICMPv6.
Has this code been implemented in modern releases of TCP?:
" Alternatively, the retransmission could be done in immediate response
to a notification that the Path MTU has changed, but only for the
specific connection specified by the Packet Too Big message.”
- It seems to expose a number of attack vectors that really should not be
exposed!!
Are you suggesting remove this text? Following this text, there are two notes.
I'd personally remove this and the notes (you decide) - more because it
says think that it opens a can of worms about transport details that are
largely beyond the scope of the document (such as whether to trust
ICMPv6 as indications of actual loss, and how this interacts with
re-packaging to a different segment size, congetsuon control, etc).
If the WG thinks retaining some text is good, I'd say (as a cautious
transport person) that we should call out a warning to people doing
transmissions...
OLD:
If the new estimated PMTU is
still wrong, the process repeats, and there is an exponential
growth in the number of superfluous segments sent.
NEW:
If the new estimated PMTU is
still wrong, the process repeats, and there is an exponential
growth in the number of superfluous segments sent.
Retransmissions can increase network load in
response to congestion, worsening that congestion. Any
packetization layer that uses retransmission is responsible for
congestion control of its retransmissions.
If you wish, cite RFC8085 and RFC4821 to let people figure this out?
(these 2 sentences come directly from RFC8085).
---
The discussion of NFS may still be a reasonable historic example, but to be
current it should really refer also to NFSv4/TCP as utlising the MTU discovery
provided by TCP, since UDP-based NFS is no longer a key application.
—
I was planning to update the reference to NFS to RFC7530. I could add text
that says something like:
The protocol changed though - so it's not just a replacement reference.
I think text should note that RFC7530 says NFS must be able to run over
a congestion-controlled transport, such as TCP.
It is recommended that NFS running over TCP utilize the MTU discovery
provided by TCP.
Other suggestions?
Maybe, you could say something like:
"RFC191 used NFS as an example of a UDP-based application that benefits
from PMTU discovery. Since then RFC7530, states the supported transport
layer between NFS
and IP must be an IETF standardized transport protocol that is specified
to avoid
network congestion; such transports include TCP and the Stream Control
Transmission Protocol (SCTP). In this case, the transport is itself
responsible for determining and using an effective Path MTU, including
implementing PMTU discovery when this is needed."
RFC8085 may well be a good place to point to say what is
needed/desirable for PMTU for UDP applications, if you wish to say
something about UDP.
There is no mention that paths including tunnels can eat ICMPv6 PTB messages on
the tunnel segment, blackholing them, which prevents reaching the destination.
As noted above, I think adding discussion about tunnels is out of scope of this
effort.
I agree that new mechanisms are out of scope, I was hoping that a simple
note on tunnels would be in the security considerations.
RFC8085 or draft-ietf-intarea-tunnels could be pointed to describe the
implications of tunnels.
---
I think the security consideration is naive!
Suggestions?
" In the first attack, the false message indicates a PMTU much smaller
than reality. This should not entirely stop data flow, since the
victim node should never set its PMTU estimate below the IPv6 minimum
link MTU. It will, however, result in suboptimal performance."
So... In the case of the first attack, I still question whether this
choice of words misrepresents the attack.
What if, the false message advertises ~1280 bytes, and the path uses a
tunnel encapsulation transporting IPv6, then the PTB message can be
basis for a straight DoS attack that does stop data flow?
I would recommend revising the security considerations (at least to
something like):
" In the first attack, the false message indicates a PMTU much smaller
than reality. In response, the
victim node should never set its PMTU estimate below the IPv6 minimum
link MTU. A sender that falsely reduces to this MTU would observe
suboptimal performance."
- Although this skirts the problem.
This statement in particular seems to open DOS vulnerability:
"
When a node receives a Packet Too Big message, it MUST reduce its
estimate of the PMTU for the relevant path, based on the value of the
MTU field in the message."
- Introdueces a significant vulnerability. A rogue PTB message that reduces
the PMTU to a minimum, can result in a path too small to carry an encapsulated
packet. (Recently noted by Fernando Gont).
Suggestions?
See below - and above.
Moreover, other layers view ICMP messages with suspicion and have long noted
the need to check ICMP payload and match only packets that relate to actual
5-tuples in use (effectively reducing vulnerability to off-path attacks). For
example, the Guidelines for UDP, rfc5405bis, state:
" Applications SHOULD appropriately validate the payload of ICMP
messages to ensure these are received in response to transmitted
traffic (i.e., a reported error condition that corresponds to a UDP
datagram actually sent by the application). …“
- clearly handling this in IP-layer tunnels can be troublesome, but that's a
problem that should be described, not obscured.
I could add something like the following as a new second paragraph in Section 4
Protocol Requirements:
Protocols SHOULD appropriately validate the payload of ICMPv6 PTB
messages to ensure these are received in response to transmitted
traffic (i.e., a reported error condition that corresponds to a UDP
datagram actually sent by the application).
or similar.
That certainly is a nod in what I think is really the correct direction.
Probably /UDP/ should be /IPv6 packet/ given the context of this ID.
——
I’d finally like to add my concerns about the understatement of the value of
PLPMTUD, which seems to not reflect the recommendations to use this method:
“ It defines a method for Packetization Layer Path
MTU Discovery (PLPMTUD) designed for use over paths where delivery of
ICMP messages to a host is not assured.”
This seems under-stating the value and recommendations to deploy PLMTUD,
compared with current transport-area recommendations, for instance, the UDP
Guidelines provide much more on this important design consideration:
The w.g. spent a lot of time on this paragraph. The intent was to point to it,
but not into detail of how it worked, nor make it a new requirement. There was
some discussion that adding more detail about the relationship between PTMUD
and PLPMTUD in the ongoing update to IPv6 Node Requirements would be helpful.
I appreciate people have spent time trying to get the IPv6
specifications progressed to standards status. This is a good effort,
but I think just adding a nod in the introduction is rather feeble for
soemthing now recommended. I think at least the security considerations
should motivate the benefits of this approach (see next).
" Packetization Layer Path MTU Discovery (PLPMTUD) [RFC4821] does not
rely upon network support for ICMP messages and is therefore
considered more robust than standard PMTUD. It is not susceptible to
"black holing" of ICMP message. To operate, PLPMTUD requires changes
to the way the transport is used, both to transmit probe packets, and
to account for the loss or success of these probes. This updates not
only the PMTU algorithm, it also impacts loss recovery, congestion
control, etc. These updated mechanisms can be implemented within a
connection-oriented transport (e.g., TCP, SCTP, DCCP), but are not a
part of UDP, but this type of feedback is not typically present for
unidirectional applications."
----
The examples used in the definition of "upper layer" and "link" also makes
this document appear as historic, rather than a new RFC!
As noted above, I think there would be support for a rewrite if some folks
wanted to take that on.
Could the WG consider to also add the first two sentences to the
security considerations?
Gorry
P.S. A few more out-dated statements abiut TCP, based on the way
specific stacks work when the original was written:
- The phrase below needs to be removed also, since not all TCP stacks
behave in this way anymore:
", which is always a multiple of the segment size"
- There was very specific detailis relating to 4.2BSD TCP
implementations, which would have been better not being here.
|
|