If a display string is not found, mhshow behaves as if these profile
entries were supplied and supported:
mhshow-show-text/plain: %lmoreproc %F
mhshow-show-message/rfc822: %lshow -file %F
Pre-1.6, that used %p indicating a pause for confirmation.
Is moreproc there really correct? Isn't it now essentially just cat with
the moreproc being applied later for all parts together? And is show's
use of moreproc also being suppressed?
Weeellll ... yeah, you're right. That should be made clearer. I think
if you specify -noconcat it will be moreproc, but it's a blank otherwise,
which is a marker to tell the display portion "just blast this straight
through".
Also, I can't seem to be able to configure this by specifying the
profile entry explicitly: cat is saying "file not found".
You're saying you tried:
mhshow-show-text/plain: %lcat %F
I would have thought that would have worked. I just tried it, and it did
for me.
I've also noticed that for messages that consist of just a single
text/plain part, it is inconsistent on whether I get a part label. Most
messages on this list are examples with no part label. I found an
example that does produce a part label and it is quoted-printable
encoded so perhaps that is making a difference. base64 and alternate
charsets may also have the same effect. I've used mime -check on this
message to try to enduce the effect.
I suspect the key there is a) you're using show, and b) the messages
that are not showing a marker do not have MIME headers. In that case
show would never call mhshow.
--Ken
_______________________________________________
Nmh-workers mailing list
Nmh-workers(_at_)nongnu(_dot_)org
https://lists.nongnu.org/mailman/listinfo/nmh-workers