Hello Folks,
Procmail has the number of lines of a piece of mail internally
since there are the operators '<' and '>', right? Is it possible to
recover this number of lines, or size, in a variable? I would like to
recover this in a variable within procmail.
Is this possible?
Thanks to all,
--Ralph
Dr. Ralph P. Sobek Disclaimer: The above ruminations are my own.
Ralph(_dot_)Sobek(_at_)irit(_dot_)fr Addresses are
ordered by importance.
sobek(_at_)irit(_dot_)fr If all
else fails, try:
newsmaster(_at_)irit(_dot_)fr, postmaster(_at_)irit(_dot_)fr
sobek(_at_)diva(_dot_)eecs(_dot_)berkeley(_dot_)edu
Ph:(+33)[0]561558618 FAX:(+33)[0]561556258 http://www.irit.fr/~Ralph.Sobek/
===============================================================================
Urgent!! Greenhouse Effect: http://www.irit.fr/~Ralph.Sobek/greenhouse.html