The initial node is in fact available, you can make it a
global variable by writing
<xsl:variable name="start" select="."/>
So saxon has this prior to instantiating the first template?
Subtle Mike... too much so for me :-)
thanks.
In my use case, it would be select="name()"/> to get hold
of 'sect2', and with a little... or a lot more work,
I guess I could find the path to root to get
/part/book/chapter/sect1[3]/sect2[4], but only if I knew
which template had been called first, which takes us on
to the rest of your comments.
It's the initial template and initial mode that aren't
available. Template names and mode names are not things
that a stylesheet normally manipulates at run-time, and I
think if we made them available it would quickly lead to
demands to specify modes and template names dynamically in
call-template and apply-templates (not that such demands
would be new).
If I know the $start value... as the stylesheet programmer,
expecting only, say, one of a few 'start points', I could
determine (non programmatically) the template that would be
called first?
E.g. in the example I gave it would be the template for sect2.
regards DaveP.
-
DISCLAIMER:
NOTICE: The information contained in this email and any attachments is
confidential and may be privileged. If you are not the intended
recipient you should not use, disclose, distribute or copy any of the
content of it or of any attachment; you are requested to notify the
sender immediately of your receipt of the email and then to delete it
and any attachments from your system.
RNIB endeavours to ensure that emails and any attachments generated by
its staff are free from viruses or other contaminants. However, it
cannot accept any responsibility for any such which are transmitted.
We therefore recommend you scan all attachments.
Please note that the statements and views expressed in this email and
any attachments are those of the author and do not necessarily represent
those of RNIB.
RNIB Registered Charity Number: 226227
Website: http://www.rnib.org.uk