Re: Who can help me to configure Cisco 2600?

cisco-nsp-request(_at_)puck(_dot_)nether(_dot_)net is the address to use to 
sign up for
one fairly well-known mailing list dedicated to cisco-specific
questions related to running a network service provider.
                                regards,
                                        Ted Hardie




> At 6:00 PM -0700 7/12/01, 
> Lorenzo_Boffelli_at_AT-ITALY(_at_)smtpgwy(_dot_)alliedtelesyn(_dot_)com 
> (Lorenz wrote:
> > I need to configure Cisco 2600 like a MGCP Gateway.
> > I use the configuration file listed at the end of the mail.
> >
> > The Call Agent can receive the RSIP message and respond with ACK.
> > After, the Call Agent send AUEP message but CISCO responds with an error.
> >
> > CISCO 2600 --> CA
> >     RSIP 1 *(_at_)Router MGCP 0.1
> >     RM: restart
> > CA --> CISCO 2600
> >     200 1 OK
> > CA --> CISCO 2600
> >    AUEP 135 *(_at_)Router MGCP 0.1
> > CISCO 2600 --> CA
> >   510 135
> >
> > Probably the endpoints configuration is wrong
> > In CISCO 2600 Documentation ( CISCO 2600 and 3600 Routers MGCP Voice Gateway
> > Interoperability with Cisco CallManager) is not clear how to configure the
> > router like a MGCP Gateway or like a Call Agent.
> > Reading this document I understood CISCO can be configured both Gateway and
> > Call-Agent
> > Is it correct?
> > Where can I find other document on this point?