OK how do I DHCP to the server on your network from my desk here?
(assuming that there are no NATs or firewalls)
If it was pure IP it would work.
-----Original Message-----
From: Ralph Droms [mailto:rdroms(_at_)cisco(_dot_)com]
Sent: Friday, April 20, 2007 1:57 PM
To: Hallam-Baker, Phillip; David W. Hankins; ietf(_at_)ietf(_dot_)org
Cc: GEOPRIV WG
Subject: Re: [Geopriv] Confirmation of GEOPRIV IETF 68
Working Group Hums
Huh? DHCP is carried in UDP and IP. There is a little
funkiness in the
DHCPv4 transport, which we wouldn't have need if IPv4
link-local addresses had been defined when RFC 2131 was
published. DHCPv6 uses link-local addresses and garden-variety IPv6.
- Ralph
On 4/20/07 1:48 PM, "Hallam-Baker, Phillip"
<pbaker(_at_)verisign(_dot_)com> wrote:
From: David W. Hankins [mailto:David_Hankins(_at_)isc(_dot_)org]
On Thu, Apr 19, 2007 at 03:38:40PM -0700, Hallam-Baker,
Phillip wrote:
DHCP is a layer 3 technology that talks directly to layer 2.
DHCP is a technology that dynamically configures hosts.
That's not the point, the point here is that DHCP is not an
Internet protocol.
It is an IETF protocol but not an Internet protocol. It
does not layer
on the IP stack.
_______________________________________________
Ietf mailing list
Ietf(_at_)ietf(_dot_)org
https://www1.ietf.org/mailman/listinfo/ietf
_______________________________________________
Ietf mailing list
Ietf(_at_)ietf(_dot_)org
https://www1.ietf.org/mailman/listinfo/ietf