Re: Document Action: 'ANSI C12.22, IEEE 1703 and MC12.22 TransportOver IP' to Informational RFC
2010-10-26 17:25:16
Hi Ralph -
Exactly what I was getting at. But a slight change in the wording you
suggested to make things clear.
Instead as the first paragraph of the abstract or as an RFC editor note I
suggest:
"This document is not an official submission on behalf of the ANSI C12.19 and
C12.22 working groups. It was created by participants in those groups building
on knowledge of several proprietary C12.22 over IP implementations. The
content of this document is an expression of a consensus aggregation of those
implementations."
This, unlike your formulation, doesn't beg the question of whether or not
"existing implementations" and "all known" means "every single one including
ones not publicly announced"
Thanks, Mike
At 05:34 PM 10/26/2010, Ralph Droms wrote:
Combining an excellent suggestion from Donald and Avygdor's clarification as
to the official status of this document, I suggest an RFC Editor note to add
the following text as a new last paragraph in the Introduction:
This document was created by technical experts of the ANSI C12.22
and ANSI C12.19 Standards, based on they first hand implementation
knowledge of existing C12.22 implementations for the Internet. It
is not an official and approved submission on behalf of the ANSI
C12.22 and ANSI C12.19 working groups. The content of this document
is an expression on the aggregate experience of all known
implementations of ANSI C12.22 for the SmartGrid using the Internet.
- Ralph
On Oct 26, 2010, at 5:25 PM 10/26/10, Avygdor Moise wrote:
Mr. St. Johns,
You ask: "Is this document an official and approved submission on behalf of
the ANSI C12.22 and ANSI C12.19 working groups?"
Answer: No it is not.
The ANSI C12.22 and ANSI C12.19 standards do not define the Transport Layer
interfaces to the network. They only define the Application Layer Services
and content.
This RFC addressed the gap as it applies to transporting C12.22 APDUs over
the Internet. However technical experts that were involved in the making,
deploying, testing and documenting the referred standards contributed to the
making of this RFC.
ANSI, NEMA, NIST, SGIP, MC, IEEE, IETF, AEIC and EEI are fully aware of this
effort and this RFC. The work was carried in plain view.
Avygdor Moise
----- Original Message -----
From: Michael StJohns
To: Avygdor Moise
Cc: ietf(_at_)ietf(_dot_)org ; IESG IESG ; Jonathan Brodkin
Sent: Tuesday, October 26, 2010 2:58 PM
Subject: RE: Document Action: 'ANSI C12.22, IEEE 1703 and MC12.22
TransportOver IP' to Informational RFC
One simple question: Is this document an official and approved submission
on behalf of the ANSI C12.22 and ANSI C12.19 working groups?
The specific language in the IESG record (in the working group summary) is
"This document was created by technical experts of the ANSI
C12.22
and ANSI C12.19 Standards, based on they first hand
implementation
knowledge of existing C12.22 implementations for the Internet.
Its
content is an expression on the aggregate experience of all known
implementations of ANSI C12.22 for the SmartGrid using the
internet."
"Created by Technical Experts of the ..." is NOT the same as "This document
was created by (or is a product of) the ANSI C12.22 and C12.19 working
groups"
If you're not paying attention, you might assume this was an official work
product of C12.22 and C12.19.
Or is this in reality a C12.22 work product? If so, why not say so? Better
yet, why not have the ANSI liaison say so?
The issue is not the qualifications of the contributors, nor the process for
creating the document, but whether or not this is a private contribution
rather than a standards body contribution. The document is NOT clear on
this and reads like a standards body submission. Given the authors
involvement with the C12 organization, a reasonable person might assume this
is an official submission even though the Working Group Notes seem to point
to an individual or private submission. It seems reasonable to clarify
which hat is being worn in terms of submission.
Mike
At 12:16 PM 10/26/2010, Avygdor Moise wrote:
Dear Nikos,
I believe that you appropriately addressed the comment and I are in
complete agreement with your remarks.
I'd would also like to point out that Mr. St. Johns' concerns are also
addressed on the IETF data tracker for this RFC (
http://datatracker.ietf.org/doc/draft-c1222-transport-over-ip/), on the
IESG Write-ups tab. Specifically there is a Technical Summary, a Working
Group Summary and a Document Quality section. These sections fully
disclose and document the origin and the processes used to produce this RFC
Draft and the qualifications of the contributors.
Sincerely
Avygdor Moise
Chair: ASC C12 SC17, WG2 / ANSI C12.19; IEEE SCC31 / WG P1377
Editor: ASC C12 SC17, WG1/ ANSI C12.22; IEEE SCC31 / WG 1703
-----Original Message-----
From: ietf-bounces(_at_)ietf(_dot_)org [
mailto:ietf-bounces(_at_)ietf(_dot_)org] On Behalf Of
ext Nikos Mavrogiannopoulos
Sent: Tuesday, October 26, 2010 11:49 AM
To: Michael StJohns
Cc: iesg(_at_)ietf(_dot_)org; ietf(_at_)ietf(_dot_)org
Subject: Re: Document Action: 'ANSI C12.22, IEEE 1703 and MC12.22
TransportOver IP' to Informational RFC
On Mon, Oct 25, 2010 at 7:39 PM, Michael StJohns
<mstjohns(_at_)comcast(_dot_)net>
wrote:
Hi -
I'm confused about this approval.
As I read the draft and the approval comments, this document is an
independent submission describing how to do C12.22 over IP. But the
document is without context for "who does this" typical to an
informational RFC.
Is that really typical? Check the MD5 algorithm in [0], I don't see
such boilerplates like "we at RSA security do hashing like that". I
think it is obvious that the authors of the document do that, or
recommend that. I pretty like the current format of informational
RFCs.
[0]. http://tools.ietf.org/html/rfc1321
Is this
a) A document describing how the document authors would do this if
they were a standards organization?
b) A description of how their company does this in their products?
Is your question on what informational RFCs are?
c) A description of how another standards body (which one????) does
this?
I'd suppose if this was the case it would be mentioned in the document
in question.
d) A back door attempt to form an international standard within the
IETF without using the traditional IETF working group mechanisms?
How can you know that? When somebody specifies his way of doing
things, is to inform and have interoperability. It might actually
happen that industry follows this approach and ends-up in a de-facto
standard. I see nothing wrong with that.
regards,
Nikos
_______________________________________________
Ietf mailing list
Ietf(_at_)ietf(_dot_)org
https://www.ietf.org/mailman/listinfo/ietf
_______________________________________________
Ietf mailing list
Ietf(_at_)ietf(_dot_)org
https://www.ietf.org/mailman/listinfo/ietf
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- RE: Document Action: 'ANSI C12.22, IEEE 1703 and MC12.22 TransportOver IP' to Informational RFC, Avygdor Moise
- Re: Document Action: 'ANSI C12.22, IEEE 1703 and MC12.22 TransportOver IP' to Informational RFC, Donald Eastlake
- RE: Document Action: 'ANSI C12.22, IEEE 1703 and MC12.22 TransportOver IP' to Informational RFC, Michael StJohns
- Message not available
- Re: Document Action: 'ANSI C12.22, IEEE 1703 and MC12.22 TransportOver IP' to Informational RFC, Avygdor Moise
- Re: Document Action: 'ANSI C12.22, IEEE 1703 and MC12.22 TransportOver IP' to Informational RFC, Ralph Droms
- Re: Document Action: 'ANSI C12.22, IEEE 1703 and MC12.22 TransportOver IP' to Informational RFC,
Michael StJohns <=
- Re: Document Action: 'ANSI C12.22, IEEE 1703 and MC12.22 TransportOver IP' to Informational RFC, Michael Richardson
- Re: Document Action: 'ANSI C12.22, IEEE 1703 and MC12.22 TransportOver IP' to Informational RFC, Avygdor Moise
- Message not available
- Re: Document Action: 'ANSI C12.22, IEEE 1703 and MC12.22 TransportOver IP' to Informational RFC, Avygdor Moise
- Re: Document Action: 'ANSI C12.22, IEEE 1703 and MC12.22 TransportOver IP' to Informational RFC, Ralph Droms
- Re: Document Action: 'ANSI C12.22, IEEE 1703 and MC12.22 TransportOver IP' to Informational RFC, Michael StJohns
- Message not available
- Re: Document Action: 'ANSI C12.22, IEEE 1703 and MC12.22 TransportOver IP' to Informational RFC, Avygdor Moise
|
|
|