With MHonArc 2.1.0 I experience the following behaviour:
1)
If an attachment filename contains blanks the generated link contains only the
first part
of the filename up to the (first) blank, f.i. in the example shown below only"
FSpec"
occurs on the html-page. Since the whole filename is doublequoted I think it
should be
possible to detect where the filename actually ends. Is this a bug?
Example header:
Content-type: Application/Octet-stream; name="FSpec KIK Template.doc";
type=MS-Word-7
Content-disposition: attachment; filename="FSpec KIK Template.doc"
Content-transfer-encoding: BASE64
2)
Sometimes mail attachments sent with Eudora for Mac get a semicolon added to
their name,
so that f.i. in the example given below the name becomes "WP3.doc;". Could it
be that
somehow the semicolon at the start of the next header line slips into the
filename?
Maybe this indicates the same bug (?) as above, namely that the quotes
delimiting the
file name are ignored.
Example header:
Content-Type: application/msword; name="WP3.doc"
; x-mac-type="5744424E"
; x-mac-creator="4D535744"
Content-Transfer-Encoding: x-uuencode
Detlef
Detlef Ruschin HHHHHHH HHHHHHH III
Heinrich-Hertz-Institut HHHHHHH HHHHHHH III
fuer Nachrichtentechnik Berlin GmbH HHHHHHH HHHHHHH
Abteilung Anthropotechnik HHHHHHH HHHHHHH III
Einsteinufer 37 III
D-10587 Berlin HHHHHHH HHHHHHH III
HHHHHHH HHHHHHH III
Tel. +49 30 310 02 -365 HHHHHHH HHHHHHH III
Fax +49 30 310 02 -213 HHHHHHH HHHHHHH III
E-mail Ruschin(_at_)HHI(_dot_)DE