I'm not sure if the following is a procmail setup problem, a sendmail
setup problem or some interaction between the two
I've got sendmail-885 installed with procmail as the local mailer, and the
behaviour is exhibited with either procmail-3.10 (which we've been using)
or procmail-3.11pre7 which I just tested.
When a message bounces due to over quota the error message that comes back
is "Can't create output: Error 0" ... here is an example error message
bounced back:
Date: Mon, 5 May 1997 16:45:12 -0400 (EDT)
From: Mail Delivery Subsystem <MAILER-DAEMON(_at_)hwcn(_dot_)org>
To: postmaster(_at_)hwcn(_dot_)org
Subject: Returned mail: Can't create output: Error 0
The original message was received at Mon, 5 May 1997 16:45:07 -0400 (EDT)
from <HOSTNAME REMOVED FOR PRIVACY>
----- The following addresses have delivery notifications -----
<USERID(_at_)freenet(_dot_)hamilton(_dot_)on(_dot_)ca> (unrecoverable error)
----- Transcript of session follows -----
procmail: Error while writing to "/home/DIR/USERID/.mail"
550 <USERID(_at_)freenet(_dot_)hamilton(_dot_)on(_dot_)ca>... Can't create
output: Error 0
----- Original message follows -----