Hi Abel,
I tested with Eclipse 3.2 - I dropped Eclipse 3.1 some time ago.
If you upgrade to Eclipse 3.2 and still have problems please contact us
at support at oxygenxml dot com (to avoid being off topic here).
Best Regards,
George
---------------------------------------------------------------------
George Cristian Bina
<oXygen/> XML Editor, Schema Editor and XSLT Editor/Debugger
http://www.oxygenxml.com
Abel Braaksma wrote:
George Cristian Bina wrote:
Hmm, with the same example I get 2 errors reported in the Errors tab
from the Results View, both with the message "Content is not allowed
in prolog.".
If oXygen detects errors and cannot find a resource to place the error
markers on then it reports them in an Errors tab in the Results view.
That should appear automatically if you are in the oXygen XML
perspective (Window -> Open Perspective -- Other... -- oXygen XML).
I tried it all. I have no error-tab. I do have a problem-tab. Both with
oxygen xml perspective and with my own (I had a changed perspective for
this). Indeed, with most errors, they popup and show up automatically.
Not this one. When I look at the console screen, all it says is:
[17:37:02] - Transformation started
[17:37:02] - Transforming file:/D:/[...]/test.xslt against
file:/D:/[....]/test/xml using Saxon8B
[17:37:02] - Transformation ended in 0.0 seconds
While with any normal situation, it says "Found xx problem(s)". Where xx
is the number of problems (normally zero I hope).
Perhaps the Eclipse version? It is 3.1.0, I have not upgraded to 3.2 yet.
-- Abel
--~------------------------------------------------------------------
XSL-List info and archive: http://www.mulberrytech.com/xsl/xsl-list
To unsubscribe, go to: http://lists.mulberrytech.com/xsl-list/
or e-mail: <mailto:xsl-list-unsubscribe(_at_)lists(_dot_)mulberrytech(_dot_)com>
--~--
--~------------------------------------------------------------------
XSL-List info and archive: http://www.mulberrytech.com/xsl/xsl-list
To unsubscribe, go to: http://lists.mulberrytech.com/xsl-list/
or e-mail: <mailto:xsl-list-unsubscribe(_at_)lists(_dot_)mulberrytech(_dot_)com>
--~--