At the interop event, some people's reflectors used From: and others
used MAIL FROM. A few people there had difficulty sending mail to those
using MAIL FROM, so everyone switched to using From:.
Personally, I can see the need for both types. So I'll be setting up a
second reflector uses MAIL FROM.
Tony
Michael Thomas wrote:
So I have a question here: is it generally the Right Thing to send to the
MAIL FROM? I've modified my reflector so that it will pay attention
to the Reply-To and could even change it to the MAIL FROM, but
I'm sort of worried that I might just be moving the problem around.
Mike
SM wrote:
At 04:56 10-04-2008, Steffen Lehmann wrote:
I have tried to check this mails against several DKIM reflectors, but
get no answer at all. I think this is because the reflector sends back
its answer to the "From" or "Sender" address, but not to the "envelope
from". Unfortunately, I cannot change the "From" or "Sender" header to
my own address - this will cause the DKIM signature to fail. Is there a
way to compel a reflector to send back its result to a certain address?
The autorespond+dkim(_at_)dk(_dot_)elandsys(_dot_)com autoresponder will
send the
results to the envelope from address.
Regards,
-sm
_______________________________________________
dkim-dev mailing list
dkim-dev(_at_)mipassoc(_dot_)org
http://mipassoc.org/mailman/listinfo/dkim-dev
_______________________________________________
dkim-dev mailing list
dkim-dev(_at_)mipassoc(_dot_)org
http://mipassoc.org/mailman/listinfo/dkim-dev
_______________________________________________
dkim-dev mailing list
dkim-dev(_at_)mipassoc(_dot_)org
http://mipassoc.org/mailman/listinfo/dkim-dev